Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Yamada, Ryohei; Odagiri, Taiki*; Iwaoka, Kazuki*; Hosoda, Masahiro*; Tokonami, Shinji*
Radiation Environment and Medicine, 8(1), p.21 - 25, 2019/02
We evaluate radon/thoron and its progeny concentration using passive-type monitors using CR-39 plates. After exposure, it is necessary to do chemical etching for CR-39 plates. In the present study, we considered shortening of chemical etching time for CR-39 and enlargement of the track diameter (i.e. etch pit diameter) aiming for introduction of automatic counting system in the future. Optimum conditions were determined by changing solution concentration, solution temperature and etching time. As a result, the optimized conditions (concentration, temperature and etching time) were determined to be 8 M NaOH solution, 75 degrees Celsius and 10 hours. This result of etching time showed that the chemical etching was completed in less than half of conventional etching time. Furthermore, it was suggested that shorter etching time would be possible if we do not consider the enlargement of conventional track diameter.
Iguchi, Kazunari; Esaka, Konomi; Lee, C. G.; Inagawa, Jun; Esaka, Fumitaka; Onodera, Takashi; Fukuyama, Hiroyasu; Suzuki, Daisuke; Sakurai, Satoshi; Watanabe, Kazuo; et al.
Radiation Measurements, 40(2-6), p.363 - 366, 2005/11
Times Cited Count：11 Percentile：59.86(Nuclear Science & Technology)In particle analysis for safeguards environmental samples, the fission track technique is very important to detect sub-micrometer particles containing uranium. In the technique the authors developed, the particles were recovered onto the polycarbonate membrane filter. The filter was dissolved in solvent and dried to form a thin film of detector, in which the particles were confined. After thermal neutron irradiation and etching, the particles of interest in the detector were easily identified with fission tracks, and were picked up for isotope ratio analysis. It was found, however, that the particles in the vicinity of the detector surface may fall off during the etching process. Therefore, optimization of the etching condition is required. In this work, the effects of etching time and enrichment of uranium in particles were investigated. Preliminary results suggest that etching time should be shorter with the increase in the enrichment.
